Regrip Golf Clubs - Step-by-Step
From Kevin Redfern, About.com Guest
Apply Solvent to New Grip and Grip Tape
Courtesy of Kevin Redfern; used with permission
Push a golf tee into the vent hole of your new grip and pour grip solvent into the open end. Then pour the solvent from the grip over the entire length of the new grip tape (don't forget to position a container under the butt end of the shaft to catch the solvent). Remove tee from grip hole. Proceed without delay to next step. (next step)
Prev
- Gather Your Tools
- Remove Old Grip
- Remove Old Grip Tape
- Clean Off Any Grip Residue
- Apply New Grip Tape
- Apply Solvent to New Grip and Grip Tape
- Push New Grip Over Grip Tape
- Check the Alignment
Explore Golf
Must Reads
About.com Special Features
Learn to Pitch
Strike out the competition with these step-by-step pictorials. More >
Introduction to Pilates
Learning Pilates fundamentals can help you get the most out of your exercise regime. More >
©2009 About.com, a part of The New York Times Company.
All rights reserved.